This particularly applies to corrosivity, permeability, softening, premature aging and embrittlement. 38 If this material shows a violent effect in laboratory tests involving heating under confinement, the labeling requirements of Special Provision 53 apply, and the material must be packaged in accordance with packing method OP6 in 173.225 of this subchapter. 336 The use of UN1H1 drums, UN3H1 jerricans, and UN6HA1 composite packagings which meet the requirements of part 178 of the HMR at the Packing Group I or II performance level. As a The proper shipping name Paint related material may be used for consignments of packages containing Paint and Paint related material in the same package; b. c. The time between offering the material for transportation at the point of origin, and unloading the material at the destination does not exceed 48 hours. c. Packagings are excepted from the design stress limits at elevated temperatures, as described in Section VIII of the ASME Code (IBR, see 171.7 of this subchapter). [Amdt. For continued use of approvals dated prior to January 1, 2012, see 173.308(b)(5). 362 This entry applies to liquids, pastes or powders, pressurized with a propellant that meets the definition of a gas in 173.115. When a specific portable tank instruction is specified by a T Code in Column (7) of the 172.101 Table for a specific hazardous material, a specification portable tank conforming to an alternative tank instruction may be used if: (A) The alternative portable tank has a higher or equivalent test pressure (for example, 4 bar when 2.65 bar is specified); (B) The alternative portable tank has greater or equivalent wall thickness (for example, 10 mm when 6 mm is specified); (C) The alternative portable tank has a pressure relief device as specified in the T Code. Codes in Column 7 may be numbers, or a combination of letters and numbers. In addition, MC 312 and DOT 412 cargo tank motor vehicles must: a. The proper shipping name Paint related material, corrosive, flammable may be used for consignments of packages containing Paint, corrosive, flammable and Paint related material, corrosive, flammable in the same package; c. The proper shipping name Paint related material, flammable, corrosive may be used for consignments of packages containing Paint, flammable, corrosive and Paint related material, flammable, corrosive in the same package; and. This includes vehicles transported in a packaging. In addition, for solid materials, special provision B54 applies. It must not freeze at temperatures above 15 C (5 F). Bulk packagings must have exterior heating coils fusion welded to the tank shell which have been properly stress relieved. TP37 IM portable tanks are only authorized for the shipment of hydrogen peroxide solutions in water containing 72% or less hydrogen peroxide by weight. N90 Metal packagings are not authorized. A210 This substance is forbidden for transport by air. A10 When aluminum or aluminum alloy construction materials are used, they must be resistant to corrosion. Radiation detection systems containing such detectors are not subject to any other requirements of this subchapter provided they are packed in accordance with paragraph c of this special provision. 142 These hazardous materials may not be classified and transported unless authorized by the Associate Administrator. 422 When labelling is required, the label to be used must be the label shown in 172.447. 386 When transported by private motor carrier only, the following corrosive liquids may be packaged in polyethylene bottles with a capacity no greater than 3.785 L (one gallon), further packed inside an open-top, heavy wall, high density polyethylene box (i.e., crate) in a manner that the polyethylene bottles are not subjected to any superimposed weight, and the boxes must be reasonably secured against shifting within the transport vehicle and loaded so as to minimize the possibility of coming in contact with other lading: Compounds, cleaning liquid, NA1760, PG II or III; Corrosive liquid, acidic, inorganic, n.o.s., UN3264, PG II; Corrosive liquid, acidic, organic, n.o.s., UN3265, PG III; Corrosive liquid, basic, inorganic, n.o.s., UN3266, PG II; Hydrochloric acid solution, UN1789, PG II; and. 159 This material must be protected from direct sunshine and kept in a cool, well-ventilated place away from sources of heat. 123 Any explosives, blasting, type C containing chlorates must be segregated from explosives containing ammonium nitrate or other ammonium salts. Net weight of contents may not exceed 15 kg (33 pounds). N5 Glass materials of construction are not authorized for any part of a packaging which is normally in contact with the hazardous material. The official, published CFR, is updated annually and available below under 81 Polychlorinated biphenyl items, as defined in 40 CFR 761.3, for which specification packagings are impractical, may be packaged in non-specification packagings meeting the general packaging requirements of subparts A and B of part 173 of this subchapter. The set to discharge for the spring loaded pressure relief device and the burst pressure for the frangible disc, as applicable, must not be greater than 2.65 bar for portable tanks with minimum test pressures greater than 4 bar; b. R1 A person who offers for transportation tank cars containing sulfur, molten or residue of sulfur, molten may reference the Sulfur Institute's, Molten Sulphur Rail Tank Car Guidance document (see 171.7 of this subchapter) to identify tank cars that may pose a risk in transportation due to the accumulation of formed, solid sulfur on the outside of the tank. Column 2 specifies the minimum test pressure, in bar (1 bar = 14.5 psig), at which the periodic hydrostatic testing required by 180.605 of this subchapter must be conducted. These notes are explained at the end of each TABLE. If a package contains both lithium metal batteries and lithium ion batteries packed with and contained in equipment, the package must be marked as required for both battery types. 167 These storage systems must always be considered as containing hydrogen. Single unit tank car tanks must have a reclosing pressure relief device having a start-to-discharge pressure set at no more than 1551 kPa (225 psig). Insulating materials may not promote corrosion to steel when wet. N42 1A1 drums made of carbon steel with thickness of body and heads of not less than 1.3 mm (0.050 inch) and with a corrosion-resistant phenolic lining are authorized for stabilized benzyl chloride if tested and certified to the Packing Group I performance level at a specific gravity of not less than 1.8. Equipment powered by lithium metal batteries or lithium ion batteries must be described using the entries Lithium metal batteries contained in equipment or Lithium metal batteries packed with equipment or Lithium ion batteries contained in equipment or Lithium ion batteries packed with equipment, as appropriate. 163 Substances must satisfactorily pass Test Series 8 of the UN Manual of Tests and Criteria, Part I, Section 18 (IBR, see 171.7 of this subchapter). N92 Notwithstanding the provisions of 173.24(g) of this subchapter, packagings shall be designed and constructed to permit the release of gas or vapor to prevent a build-up of pressure that could rupture the packagings in the event of loss of stabilization. These detectors must have a minimum burst pressure of 1800 kPa as demonstrated by design type qualification testing; and. b. Lading must be blanketed at all times with a dry inert gas at a pressure not to exceed 103 kPa (15 psig). TP6 The tank must be equipped with a pressure release device which prevent a tank from bursting under fire engulfment conditions (the conditions prescribed in CGA pamphlet S-1.2 (see 171.7 of this subchapter) or alternative conditions approved by the Associate Administrator may be used to consider the fire engulfment condition), taking into account the properties of the hazardous material to be transported. A100 Lithium ion cells and batteries must be offered for transport at a state of charge not exceeding 30 percent of their rated capacity. N43 Metal drums are permitted as single packagings only if constructed of nickel or monel. Specifically, you seek clarification on the implementation of special provision IP15which is listed in Column 7 of the 172.101 Hazardous Materials Table (HMT)as it applies when this material is packaged in a composite intermediate bulk container (IBC) with a rigid inner receptacle. 332 Magnesium nitrate hexahydrate is not subject to the requirements of this subchapter. Effective January 1, 2012, for transportation by vessel, this entry may only be used if the results of Test Series 6(d) of Part I of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter) have demonstrated that any hazardous effects from accidental functioning are confined to within the package. TP7 The vapor space must be purged of air by nitrogen or other means. Shipments made in accordance with this Special provision are excepted from the requirements of 173.60(b)(4) of this subchapter. Flexible, fiberboard or wooden IBCs must be sift-proof and water-resistant or be fitted with a sift-proof and water-resistant liner. During transport, it must be protected from direct sunshine and stored (or kept) in a cool and well-ventilated place, away from all sources of heat. (ii) One bottle for every two hours of production, or for every 2,500 bottles produced, must be tested by dropping a bottle filled to 98 percent capacity with water from a height of 1.2 meters (3.9 feet) onto solid concrete directly on the closure. The means of protection must be approved by the approval agency designated to approve the portable tank in accordance with the procedures in part 107, subpart E, of this subchapter. (9) W codes. It is shown that it does not pose a significant risk in transportation; b. View the most recent official publication: These links go to the official, published CFR, which is updated annually. For the purpose of this special provision, vehicles are self-propelled apparatus designed to carry one or more persons or goods. In addition, there are over 300 numeric codes provisions. . - Other Regulations Relating to Transportation, - Pipeline and Hazardous Materials Safety Administration, Department of Transportation, - Hazardous Materials Table, Special Provisions, Hazardous Materials Communications, Emergency Response Information, Training Requirements, and Security Plans, - Table of Hazardous Materials and Special Provisions, https://www.ecfr.gov/current/title-49/subtitle-B/chapter-I/subchapter-C/part-172/subpart-B/section-172.102. full text search results Table 2 defines IP Codes on the use of IBCs that are assigned to specific commodities in the 172.101 Table of this subchapter. Others such as copper and silver are available in trace amounts. Interpretation Response Details. (2) They must be packed in strong outer packagings and the completed package must be capable of withstanding a 1.8 meter (5.9 feet) drop without leakage of gas contents from detectors. Special Provision Letter Codes Used in Hazmat Table, Column 7 Column 7 uses eight letter codes. The material must be packaged so that the percentage of diluent does not fall below that stated in the approval at any time during transportation. A13 Bulk packagings are not authorized for transportation by aircraft. A54 Irrespective of the quantity limits in Column 9B of the 172.101 table, a lithium battery, including a lithium battery packed with, or contained in, equipment that otherwise meets the applicable requirements of 173.185, may have a mass exceeding 35 kg if approved by the Associate Administrator prior to shipment. B11 Tank car tanks must have a test pressure of at least 2,068.5 kPa (300 psig). 132 This description may only be used for ammonium nitrate-based compound fertilizers. When no IB code is assigned in the 172.101 Table for a specific proper shipping name, or in 173.185 or 173.225(e) Organic Peroxide Table for Type F organic peroxides, use of an IBC or Large Packaging for the material may be authorized when approved by the Associate Administrator.